case chamfering

[yakmon]

i've heard that this direct link dosnt work so if you go to this link and search for p/n SP375A . my question is does or has anyone ever used a tool like this for inside chamfering of rifle cases? i use it and i like it. 2 turns per case

[GeoffLinder]

RCBS deburring tool here for standard deburring and chamfering. It's big plus is it will chamfer inside AND outside of case mouth. The RCBS leaves a 45 degree chamfer.

I use a 17 degree chamfer tool to help seat match grade bullets very gently for my precision rifle loading. It's made by Lyman and called the VLD reamer.

The one you linked to is a 100 degree cutter angle so it's only de-burring and not leaving you a chamfered lead-in for easier bullet seating.

[yakmon]

granted, this tool is used for deburring rivit holes in aircraft, i just happen to have one in my toolbox and thought i'd use it to chamfer a s**t ton of brass without wearing out my fingers on a wilson tool.

[bumpo628]

Possum hollow makes an adapter that let's you use the standard tool in a drill:

http://www.midwayusa.com/viewproduct/?productnumber=295771

[CSACANNONEER]

Looks harder to use than a Wilson. But, obviously, I'm wrong. How did you use it? Do you hole it stationary or the cases?

[yakmon]

Looks harder to use than a Wilson. But, obviously, I'm wrong. How did you use it? Do you hole it stationary or the cases?

hold the case stationary in one hand and crank away with the dog bone. if i could find a cutter with the wilson chamfer angle on one end and a 1/4" /28 thread on the other id be in heaven.

[swerv512]

i just screw a VLD chamfer tool next to an RCBS debur tool on my case mate and forget about the rest....

[dadswickedammo]

I install my rcbs chamfer tool on my 1/2'' drill press do 1000 inside flip the tool over and do it again. good and as fast as it gets