Tweet
i dont know if someone has done this trick or not but here is a setup for a pro 1000 i did. get a small plastic funnel at your local dollar store and trim the rim off so that it will fit the underside of your press where the big open area is. take a measurement in relation to the spout and mounting bolt holes. drill a 3/4" hole in your bench so the spout will fit in when you bolt your press up. i used a small peanut jar and screwed the cap with a 3/4 hole in it to the bottom of the bench and screwed the jar up. everytime you deprime the primer will end up in the jar. simple.
-
Last edited by jamesob; 10-02-2011, 5:34 PM. -
Primer cups come with Big Blue; but a good idea, nonetheless.sigpic
"They who can give up essential liberty to obtain a little temporary safety, deserve neither liberty nor safety." --- Benjamin Franklin
Freedom isn't free. Read the Declaration of Independence everyday - it'll keep the New World Order away.
Quote: Army: "Your ignorant liberal puke rhetoric is tiresome."
We live in a society of extreme behavior with no electronic self control. -
I found that the spent primer cup on the Dillon XL-650 pretty worthless so I did the following: http://forums.1911forum.com/showthre...ght=Chief-7700
XL-650 to feed the: .45ACP's Les Baer Concept V, Ruger SR 1911, Ruger Nightwatchman,custom built Colt M1911, Springfield .45ACP Loaded.. 9MM SA Range Officer,Ruger P-85, Springfield Stainless 9MM loaded, SA 9MM 5.25" XDM, Springfield 9mm Stainless Range Officer, STI double stack .45ACP.
IDPA A41750 Safety Officer
NRA Certified RSO
"Stay out of the deep end of the pool; correct the problem with your credit card, not your dremel!"Comment
-
I just jigsawed out the bottom area of my table were the press sits and put a big jar there...
no need for the funnel : )Sandstorm Custom Rifle Slings : Custom Paracord slings
10% off slings for calguns members. PM for details. Like us on facebook!Comment
There are currently 6288 users online. 120 members and 6168 guests.
Most users ever online was 239,041 at 10:39 PM on 02-14-2026.
Comment