Unconfigured Ad Widget

Collapse

Working up a load

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • five.five-six
    CGN Contributor
    • May 2006
    • 34947

    Working up a load

    Saturday, I get a rare opportunity to go to the range, I am trying to work up a load for 69gn SMC with varget. my manuel does not list varget, however the data I found at the hodgdon website seems consistent with other loads I have read about and discussed with others




    so I assembled 4 sets of 5 cartridges, with 24, 25, 25.5 and 26 grain charges

    Is that enough resolution, or should I be adding more intermediary charges?
  • #2
    krzgoat
    Member
    • May 2009
    • 408

    Looks good to me. That's what I usually do when working up a load. Only thing you might add is 5 rounds of 24.5.

    I have found with my rifle that my rifle likes the low end or just above when it comes to powder.

    Comment

    • #3
      gregm727
      Junior Member
      • Nov 2009
      • 13

      It's fine for the first round of testing. I usually work the last full grain in 0.2 grain increments up to the maximum. If fine accuracy is found at some particular charge weight, the next session would be at increments of 0.1 grain weights, half a grain above and below the nominal. Unless of course best accuracy was at the max.

      Comment

      • #4
        joelogic
        Calguns Addict
        • May 2008
        • 6597

        I go at least every .5gr and 10 rounds per set. I do 10 rounds instead of 5 in case I get odd results and I can try again. You only have to do this once per gun/powder/bullet combo so who care if it take 50+ rounds.
        Micro/Mini Reflex Red Dot Sight Mount for the M1, M1a/M14 platform

        Comment

        • #5
          kmca
          Senior Member
          • Oct 2005
          • 2371

          Check out this thread:

          post #14. Looks pretty interesting.

          Comment

          • #6
            five.five-six
            CGN Contributor
            • May 2006
            • 34947

            thanks guys... course, I could have saved a bunch of time buy just listening to what all the old hands told me 24" barrel 1:9 twist - 26 grain varget with 69 grain SMC, makes 3/8" at 100m

            nuff said

            Comment

            • #7
              California-Quigley
              Member
              • Feb 2006
              • 112

              24.8gr, win brass, fed 205, .25" at 100!!

              Comment

              • #8
                Bug Splat
                Calguns Addict
                • Dec 2007
                • 6561

                I have found my rifles like 24.5gr of Varget with 69gr SMK. I also work up a load starting at the base and increasing .5 till I get to the max load. I'll load of 10 rounds of each. Always start with the lightest load and always check for over pressure signs after each round. I've had rounds well under the max load show signs of over pressure in one rifle for some reason.

                Comment

                Working...
                UA-8071174-1