RELOADING BENCH PICTURES

[Braddah Jay]

image


image


Still need to paint the bench and walls of the garage. Going to use a grey epoxy paint on the bench and stick with off white on the walls. I installed t-track into the bench and onto the shelf above so if I want to store something out of the way, I can put it on the top shelf. With the t track, I can move the press and powder measure to wherever I want. The primer/bullet shelf is a x54r crate. The 223 round hanging on the chain is the pull cord for the light. The feet on the bench are self leveling and adjustable.

It's been a ton of work building everything. There was nothing there when I started. I built everything myself and even had to run a new circuit for the light and outlet which was a pita because of the tight working space in the attic. The bench has it's own dedicated 20a breaker so I can run whatever I want from the workbench.

I would recommend moving that powder drop & jars of powder away from that water heater... Just saying..."Kaboooooom!"

[sdkevin]

Just saying..."Kaboooooom!"

Braddah, no need for chem classes, your thc is 'da boom.

[kielbasavw]

This is my setup, I have a very old craftsman rollaway tool box that holds some tools and powders. Im still adding little by little.

[stevied]

I would recommend moving that powder drop & jars of powder away from that water heater... Just saying..."Kaboooooom!"

The powder drop is empty and the caps are tight on the powder. It does not give off vapor like gas so I don't see what's could go boom? Even if all of the powder fell down next to the pilot on the water heater, they wouldn't catch fire.

[Cworthy]

Still a work in progress, but it gets the job done for now.

[dbash]

Finally posting my set up.

Here it is.

[GJC]

Here it is.

Nice!

[kygen]

am I missing anything?


note, the channel locks can be used for seating, crimping and even pulling bullets apart in a pinch

This is more my speed

[Rider1k]

a work in progress. Does it's job for now

[kalapa]

My little operation. Only loading 9mm right now.

[peacedivision]

Apartment dweller reloading

[Duds0311]

New to the group, new to reloading, but this is my set up in my apartment.

[drkphibr]

The bench already contains a LCT press permanently mounted on each end, so I needed to come up with a different approach for the LnL. I decided to go with a custom built heavy mobile design.

[1in9twist]

The bench already contains a LCT press permanently mounted on each end, so I needed to come up with a different approach for the LnL. I decided to go with a custom built heavy mobile design.

Lookin good man, nice to see you kicking around in here.

[Germz]

Apartment dweller reloading

seems like quite a stretch to have to move from the press all the way to the other end of the table in order to start charging. I feel ya, apartment reloading setups can be cumbersome.