Unconfigured Ad Widget

Collapse

Casting for 357 Sig

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Gnzrme
    Senior Member
    • Oct 2007
    • 908

    Casting for 357 Sig

    I realize that probably not many of you cast, but I have posted this on Handloads and on Cast bullets....I am trying to cast 357sig to shoot out of a Sig229. The 357 sig is a finicky round to load for in that you have to get the crimp and seating just right or your bullet will just spin in the case and you will get setback on chambering...

    Anybody casting out there for this and what mold are you using and how deep are you seating and what are you shooting it out of and whats your load...
  • #2
    J-cat
    Calguns Addict
    • May 2005
    • 6626

    I have reloaded for this round extensively, although not with cast bullets. You have alot working against you: Short neck, short neck and short neck.

    At least with jacketed bullets, you have metal on metal contact between the bullet and the neck. This friction keeps the bullet in place, not crimp. With cast bullets, you have a mini neck and lube. You have to dig the case mouth into the bullet shank to prevent setback. This is problematic because as you dig the case mouth into the bullet shank, the case neck peels away from the bullet shank, so the whole thing is counterproductive.

    Maybe if you had a special mold with a crimp groove and a short nose?

    Comment

    Working...
    UA-8071174-1