Loading 223 with a Dillon 650

[Henry Shooter]

Good evening Folks
I have been reloading for awhile and have a Dillon 650 that I would like to start loading 223 for the new AR's I recently aquired. I have the conversion head and the dies, Dillon, What I would like to know is what you all are using for the powder measure. I have heard that the stick powder does not meter well through the dillon. Also, what powder you are using for consistant loads.
Thanks

[Fjold]

BL(c)-2 or any of the Hodgon H ball powders.

[Trapper]

Varget or RL-15 with a 69gr SMK
N-130 with a 60gr Sierra HP

[gose]

H335

[joelogic]

H322

[domokun]

Currently it is Varget or Win748 due to the fact that's what I have plenty of right now.

[Corbin Dallas]

Large powder bar and 26g of win748

[LexLuther]

I use a2230 and it works great. best .39 cents you can spend is to go to ace hardware and find a flourette(sp?) nob for your powder adjustment.

[mvpatriot]

I run varget, h335 and tac for my 223. You can also refer to my reload vids below for the 650 themy might help out a bit.

[JamesY]

H-322 is currently in my 650. Consistently puts out 23.1gr behind a 55gr FMJ. I'm happy so far. Next, I'll try WCC-846 for some 308 plinking loads. Hope it meters well.

[Henry Shooter]

Thanks Y'all. Good info.

[California-Quigley]

very good info. if you were dead set on the other shaped powders, dillon makes a powder die conversion so you can use another powder measure...

i use

H335 and H332, varget as well