Setting Up Mec Grabber

[tabascoz28]

It is cool how this machine is set up, all the linkages and interdependent operations. I guess I should have watched some setup videos and read the instructions a few times. Change one thing and it could throw off something way down the line or in this case up the line, spilling powder and shot all over the place. After a bunch of tweeks now I can finally get productive!

[ceh383]

I've got 2 9000's, I've seen hulls like that
When setup they do produce nice shalls.

[tabascoz28]

So you know, I put the wad guide lower for clearance, but when too low, it doesn't drop the 1st shell deep in the sizer. I just thought I was too weak to push all 6 stations down.
I also had the sales sticker on the charge bar and that created a bind. Had to alcohol and scrape that clean along with the machine. But now it's purrin'.

[ar15barrels]

So you know, I put the wad guide lower for clearance,
but when too low, it doesn't drop the 1st shell deep in the sizer.

Setup the wad seater with the clamp screw loose and the seater ram too long so that the seater ram will slide up as you seat the first wad.
THEN tighten the clamp screw to lock the seater length in place.
If you need more wad pressure, you extend the seater from that baseline "touching" length until you get the indicated pressure you are looking for.