Tweet
Hello everyone this is temp setup for now my concern is the press clearing the table or is it just right? My block might be too thick?
-
-
I just clamp mine directly to my shelf.Last edited by heavyhaulin818; 11-04-2021, 10:21 PM. -
The mounting surface of the press is machined flat. There is a lip (edge) that should not make contact to the mounting surface. That is your clearance for the press to operate.Been gone too long. It's been 15 to 20 years since i had to shelf my guns. Those early years sucked.
I really miss the good old Pomona Gun Shows.
I'm Back.Comment
-
Got it thanks i moved the block closer to the edge to get clearanceComment
There are currently 14613 users online. 165 members and 14448 guests.
Most users ever online was 239,041 at 11:39 PM on 02-14-2026.
Comment