Franklin rocks!

[Red9]

So my FART motor started to slow down, and stop and then just hum. I emailed tech support to see if they sell just the motor and I'd install it.
Well they are sending a replacement! My unit is four years old and I've cleaned alot of brass. Great product and support.
Thought I'd share a nice experience.

Sent from my T790W using Tapatalk

[WartHog]

OUTSTANDING!!!

[golfish]

That's good to hear....

[pacrat]

So my FART motor started to slow down, and stop and then just hum. I emailed tech support to see if they sell just the motor and I'd install it.
Well they are sending a replacement! My unit is four years old and I've cleaned alot of brass. Great product and support.
Thought I'd share a nice experience.

Sent from my T790W using Tapatalk

Excellent CS!

Typical symptoms of small induction motors when they need lubrication.

When you get the new one in and running. Use this https://www.amazon.com/3-in-ONE-Moto...00065VGUC?th=1 to replenish the felt reservoir pads on the "oil lite bushings", of the take out. Spin by hand to brake the glaze between the shaft/bushings. Then start it up. And oil it a few more times to assure the bushings are well saturated.

Set it aside as a spare.

[Red9]

Update.
They sent a whole unit!

Sent from my T790W using Tapatalk

[middleofnowhere]

One of the things about stuff from China is it is cheaper to replace than to repair.

[DDRH]

great to hear. i have their large and small FART. mostly use the small one for 100-200 case batches (rifle cases)