650xl problem help

[skyline]

So I have been using my dillon 650xl for a couple of years now and this has never happened to me before
And I can't seem to find out why it only does it once in a blue moon

Sent from my SM-N976V using Tapatalk

[nimbus]

Align your shell plate and make sure you’re using the right locator pins. The expander in the powder measure makes those dents when things don’t line up.

[BajaJames83]

^ that make sure everything is advancing and the shellpate is in the right position. Maybe check thr bolts underneath

[bruce381]

only to add clean shell plate the rims may not be fully getting inserted also check the case "pusher" thing and adjust

[Raiderh20boy]

Is that happening in station 1? Happens to me sometimes when I don’t go complete down stroke and then it happens on the up stroke
Or maybe on the opposite ����

[tabascoz28]

Is that catching on the primer pin? You must have that jamming, I am almost always slow stroking...

[skyline]

I think you are right about the slow stroking I take my time I am not trying to crank out 500 a hour I tent to take my time with components being so scares


Sent from my SM-N976V using Tapatalk

[Raiderh20boy]

What station?

[MrElectric03]

Usually happens to me when the case doesn't slide in the station one locator and gets jammed into the casefeed body bushing or doesn't fully seat into the shellplate and jams into the die.

[P08]

[Corbin Dallas]

Align your shell plate and make sure you’re using the right locator pins. The expander in the powder measure makes those dents when things don’t line up.

THIS!

I had the same issue and it turned out to be the indexing ball spring.

[ysr_racer]

Has anyone suggested check the alignment yet?