Unconfigured Ad Widget

Collapse

Requesting .44mag 225gr FTX data

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • hitthecoast
    Banned
    • Dec 2018
    • 341

    Requesting .44mag 225gr FTX data

    Powder charge data and OAL measurements needed for 44 Magnum loads using AA#9 powder and 225gr Hornady FTX bullets. Shooting out of a 8.5" S&W 629. Picture below is all I could find online, still need OAL data. Why does the FTX have two canneluers, which one should I crimp at for use in my revolver?

  • #2
    Sandspider500
    Senior Member
    • Apr 2018
    • 1146

    Hornady .44 Magnum data for the 225-grain FTX bullet suggests trimming cases from
    1.275/1.285 inches to 1.255 inches and seating bullets for an overall cartridge length of 1.645 inches, which is still some .035 inch greater than industry standards. This loading procedure is suggested so that cartridges will feed and function in most guns; however, some rifles still would not feed correctly with the longer cartridges.On the other hand, most U.S. manufactured revolvers readily accept cartridges that are greater than suggested industry overall lengths. The following data was developed using standard length .44
    Magnum (Starline) cases of 1.280 inches, and with the FTX bullets roll crimped in their cannelure for an overall length of 1.670 inches. With this, I was able to reach and even exceed the velocities of Hornady factory loads with several powders while staying within maximum average pressure (MAP) guidelines.Data for other 225-grain jacketed bullets should not be used with the 225-grain FTX, as it seats comparatively deeply, reducing powder capacity. It also features an unusually long bearing surface that is .068-inch longer than the 240-grain Hornady HP-XTP. Both features will raise chamber pressures
    significantly and therefore “maximum” loads should not be exceeded.
    Seating the FTX will require a seating stem (aka “plug”) that is profiled to fit the ogive of this spitzer-shaped bullet. Traditional flatnose stems often deform the bullet nose, and due to the FTX’s rather soft construction, may cause bullets to actually begin “expanding” when being seated. It is also suggested to crimp bullets as a separate step after they are seated to correct depth.

    NON TRIMMED CASES 1.275 TO 1.285 OAL 1.67 RUGER BLACKHAWK 5 1/2" Winchester LPP
    225 Hornady FTX Accurate AAC-9 17.0 1215

    225 Hornady FTX Accurate AAC-9 19.0 1316

    225 Hornady FTX Accurate AAC-9 20.0 1369

    225 Hornady FTX Accurate AAC-9 21.0 1425


    Remarks: Exceeds MAP/REDHAWK ONLY
    225 Hornady FTX Accurate AAC-9 22.5 1559


    TRIMMED CASES TO 1.255 OAL 1.645 Winchester LPP Ruger blackhawk 5 1/2"

    MAXIUM LOAD
    225 Hornady FTX Accurate AAC-9 15.1 1110
    Originally posted by Palmaris
    You should not worry about me. This web site is monitored by all kind of authorities and if they found this kind of post credible enough as threat, they might want to start investigation. I have no idea what can be outcome. Just saying.

    Comment

    • #3
      hitthecoast
      Banned
      • Dec 2018
      • 341

      Great much appreciated

      Comment

      Working...
      UA-8071174-1