DIY Tools

[Dragginpanda]

I use an empty cut up Japanese peanut container to catch my casings when I deprime. Anyone else have some tools that were DIY or not their original intended use?

[anonymouscuban]

My case feeder.

https://youtu.be/89wxETbHDD0

Sent from my SM-G930U using Tapatalk

[robodeer]

My case feeder.

https://youtu.be/89wxETbHDD0

Sent from my SM-G930U using Tapatalk

How much (approx.) would it cost in filament to print out parts like that? Designing and printing your own parts seems like fun.

[anonymouscuban]

How much (approx.) would it cost in filament to print out parts like that? Designing and printing your own parts seems like fun.

About 15 bucks.

Sent from my SM-G930U using Tapatalk

[brix]

Child mirrors and clamp from Daiso......$3 each, make great mirrors for my case and bullet feeder. The green one is from the 99 cent store

[brix]

Also have this spring from a spring assortment kit from Home Depot i use for my Mr Bulletfeeder.....helps close the feeder when the brass weight isn't enough. The entire assortment kit is $5 and worth ever penny.

[reverser]

I made a tumbler with an old drill press motor and 6” pvc pipe. Don’t remember the pulley ratio I went with but it works really well. Thinking about adding another pulley to run a trimmer off of but haven’t gotten around to that yet.

[wpod]

I took a miter saw stand and bolted a boat winch to it to make a draw board (archery related).
Then used a trailer jack to make a bow press. The adjustable fingers I made from 3/4" thick angle and square tube, all aluminum.
Added a vise on the end made from 1" aluminum round bar.

https://youtu.be/JTXKPMTRY_k

Sent from my SM-G955U using Tapatalk