Tweet
Can anyone help with posting a few photos?
I found what appears to be a vintage uniflow II with the stand attached. The stand has been drilled and tapped and has to allan head screws installed. They aren't holding anything together, they're just sticking out of the top of the stand by a few inches and are sunk into the top of the stand by 1/4" or so. Why would anyone do this? It doesnt appear factory but they did a decent enough job I guess it could be but I've never seen it before.
The powder measure has "uniflow" on one side and has two capital letter "I's" cast into the metal just below it.
On the opposite side its marked "RCBS" and just below that it is marked with a capital "O".
Thank you in advance for any input anyone can provide.
I found what appears to be a vintage uniflow II with the stand attached. The stand has been drilled and tapped and has to allan head screws installed. They aren't holding anything together, they're just sticking out of the top of the stand by a few inches and are sunk into the top of the stand by 1/4" or so. Why would anyone do this? It doesnt appear factory but they did a decent enough job I guess it could be but I've never seen it before.
The powder measure has "uniflow" on one side and has two capital letter "I's" cast into the metal just below it.
On the opposite side its marked "RCBS" and just below that it is marked with a capital "O".
Thank you in advance for any input anyone can provide.
Comment