Unconfigured Ad Widget

Collapse

Deburring

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • JackEllis
    Veteran Member
    • Nov 2015
    • 2731

    Deburring

    I need to fine tune the prep on a bunch of .223 cases that were sized using a Lee Power Trim with dull chamfer/burr cutters. It seems like chamfering the inside is a little more critical than dealing with the burr on the outside of the case neck but I also don't want to get to the range or into the field and find out I have a bunch of rounds that twon't chamber. BTW these cases are for practice ammunition and varmint rounds. They aren't meant to be match quality.

    The SAAMI spec calls for an outside diameter at the neck of .253 inches. The one case I measured with a sizable burr comes in at .253. When I remove the burr, it's under .250. And so that raises the following dumb question: When a round is in the chamber, which section of the case is the reference that ensures the centerline of the bullet is properly aligned with the centerline of the bore? Is it the body, the shoulder or the neck?
  • #2
    ar15barrels
    I need a LIFE!!
    • Jan 2006
    • 57198

    Originally posted by JackEllis
    When a round is in the chamber, which section of the case is the reference that ensures the centerline of the bullet is properly aligned with the centerline of the bore?
    Is it the body, the shoulder or the neck?
    Which ever feature that fits tightest in the chamber.
    Usually the bullet.
    Randall Rausch

    AR work: www.ar15barrels.com
    Handguns: www.handgunbarrels.com
    Bolt actions: www.700barrels.com
    Foreign Semi Autos: www.akbarrels.com
    Most work done while you wait on a scheduled shop visit.

    Comment

    • #3
      JackEllis
      Veteran Member
      • Nov 2015
      • 2731

      Thanks Randall.

      Comment

      Working...
      UA-8071174-1