Hornady 9mm HAP 115gr. load data needed.

[czuleget]

I have been looking High and low for the load data for this round. It is not on the 9th addition of Hornady's book. Looking for C.O.L. and the load, Using Unique powder. What I have found is that the HAP round is similar to the HP XTP round. Most if not all Information on the web I have found is from 2014 or earlier.

Thanks again for all the replies. Midsouth shooter has a sale going on. Free shipping as well. Cost per each is .09 cents you have to buy the case at 3K

Thanks in advance.
Tony C

[kcstott]

Take data from any jacketed 115 gr bullet and use it. coal is just smaller than your magazine.
This stuff ain’t hard. Figure it out. 4-5 gr of unique should be fine. A little hot but fine.

[Mayor McRifle]

I used 125 grain HAPs for USPSA before switching to 147 grain bullets. I used 3.6 grains of Titegroup with an OAL of 1.070” in an SP-01 for a Power Factor of 130. Use XTP load data for the HAPs.

[Boris_LA]

I use similar load 125gr HAP, OAL 1.070", TG 3.5gr for CZ SP-01 for Bullseye. Velocity 1020-1040fps. Most accurate in my gun - about 2" at 50m

[czuleget]

Confirmed with Hornady.

I just got off the phone with the Hornady rep. he confirmed the HAP projectile is the same Data as the XTP. 1.075 C.O.L. and WIN 231 is similar to the Unique powder I use. So in the 9th addition of the Hornady Reloading data hand book the data for the XTP is = to the HAP.