Small primer 308 Winchester cases?

[kcstott]

Could you mike the case head and tell us the diameter? Thx.

FYI it's Mic not Mike
Out of the few i checked .4685" my old Lapua is .4705"

You asking to see if you can run it in a gas gun??

[kcstott]

That can be your opinion. They aren't owned by remington.

And we will leave it at that

Sent from my SM-N950U using Tapatalk

Well I call my self the internet idiot today. I mis read what was being sold. Thought it was Remington brand brass. I stand corrected

[OpenSightsOnly]

Have you used Lapua before, or was that a one-time purchase?

If you still have that lot, did you contact Lapua about that issue?

[kcstott]

Have you used Lapua before, or was that a one-time purchase?

If you still have that lot, did you contact Lapua about that issue?

I've shot lapua for three years. (two different batches) and No i didn't contact them yet.

[J-cat]

FYI it's Mic not Mike
Out of the few i checked .4685" my old Lapua is .4705"

You asking to see if you can run it in a gas gun??

No, just to see how close to LC dimensions they are. I hate undersized 308 brass.

[OpenSightsOnly]

FYI it's Mic not Mike
Out of the few i checked .4685" my old Lapua is .4705"

You asking to see if you can run it in a gas gun??

I ended up emailing them about their .308 match brass and gas gun use

[kcstott]

I ended up emailing them about their .308 match brass and gas gun use

it'll work and work just fine. just don't mix bolt gun brass with gas gun brass. I thinks it's over kill but sure when it's the same price as Hornady go for it. I have dedicated batches of brass for each rifle in a given caliber. I don't mix them either.

People that I have taken shooting can't seem to wrap their head around that concept.

[tonyjr]

It took a while for my nephews to see the difference between
my 3 45s . One likes CFE pistol [ used to be HS6 ]
one likes HS6 and the other hp38 all either 155 or 160 pills .
I have tried different things to mark cases but cleaning them
takes off nail polish and magic markers . We fire one at a time and
those cases go into their own plastic box [ so far nail polish on
magazine , inside 45 where mag goes and on plastic ammo box ]
The nephew are starting to I D the cases for 2 308 and one 762
and 2 223s .
Has anyone found a way o I D cases other than head stamps ?
We use a lot of range brass