Older Barnes X-bullet data anyone? Or 300/350 TSX/TTSX for 458 WinMag loads...

[Spyder]

I'm getting anxious to load, and don't want to wait until Monday to call Barnes. There's not much info out there on loads for the 300 and 350 TSX and TTSX in a .458 WinMag. If anyone has an older book with that info, can you stick a picture up for me?

[G-Man WC]

https://www.loaddata.com/articles/PDF/BenchTopics%2079%20LR1.pdf

[Spyder]

That seems to be about the only thing out there. It's printed and on my desk. I want more.

[M1NM]

I've only loaded for 300 and 500 for my 458. I found the data on the powder makers web site. If I remember I used Reloader 7.

[Spyder]

Yea, there's a fair amount of info for reloder 7 for lead bullets, but not much for the all coppers.

Ideally, I'd like to use these 325 grain Cutting Edge bullets I picked up. I figure 350 TSX or X bullet loads are a good safe starting place to start messing with them.

[Divernhunter]

The Hodgdon website has data for the 300gr TSX and TTSX bullets.

The old data for the X-bullet really does not apply to the TSX and TTSX bullets but I have it. PM me if you still want it.

[Spyder]

PM sent!

[Spyder]

DivernHunter, thanks...They just emailed me back, much quicker than last time I tried! Only time I've been near phone service since was late late night and early early morning, or I woulda called.

[Divernhunter]

Good luck.

Look for ones like these or bigger.