Ok, tired of bolting the press to some wood and clamping that to the workbench. I had some leftover 2" tubing and some plate, so a little time tonight with the plasma cutter and welder left me with this. 

The outer tube is going to get about a 6x8 piece of 3/16 plate welded to it, then I'm notching the front of the workbench and bolting it to the bottom side of the workbench top. (workbench is 3/4" ply top). It will put the base of the press about 5" higher than the workbench which is about right.
More pictures to come as I finish it over the next couple nights. I'm thinking I'll cut the plate down tomorrow to make it a bit smaller, it was a scrap peice that was 18x18". Pics are here: http://wolfenet.org/gallery2/v/Misc/reload

The outer tube is going to get about a 6x8 piece of 3/16 plate welded to it, then I'm notching the front of the workbench and bolting it to the bottom side of the workbench top. (workbench is 3/4" ply top). It will put the base of the press about 5" higher than the workbench which is about right.
More pictures to come as I finish it over the next couple nights. I'm thinking I'll cut the plate down tomorrow to make it a bit smaller, it was a scrap peice that was 18x18". Pics are here: http://wolfenet.org/gallery2/v/Misc/reload


Comment