shim washers for dies

[tonyjr]

The shim washers are back in stock . For those that don't know what I am talking / posting about - these are washers that go between the reloading die and what ever you are using . They raise the wrench used on die nut up so you don't scratch / gouge tool head / turret / single stage head . To me they are better than the o-rings .
I was down to about 10 [ they bend easy and get tossed ] I have 15 turret heads and each uses 5 dies
This is a different company , so I will see if they are OK . If interested either reply or email me - it will take a week or 2 to get here [ Xmas and all ]
e-bay - (100) 7/8" Flat washer - Narrow - .876 x 1.125" x .060 Shim - Polaris 7555790
listed / search 7/8 shim washer

[fguffey]

I do not secure the lock ring to the die meaning I adjust my dies ever time I use them. Some reloaders secure the lock ring to the die, I secure the die to the press with the lock ring.

F. Guffey

[tonyjr]

I do to . I have the box wrench to lock in place .
the tool / die holder was / were getting scratched .
I found a brass washer fit them from facet kit . went
down and bough all they had . Then I found them on
ebay .
Been buying them 100 at a time but last time they
were out of stock - did the remind me if they get posted .
I ordered another 100 - I reload for relatives to