Miwall Corp Factory Reloads

[fallfornoone]

Has anyone shot these before. i got a case of there .223
they seemed to fire good but on the last shot my bolt catch would not engage. one member says this maybe due to these loads being light. i posted this thread earlier:

http://www.calguns.net/calgunforum/showthread.php?t=144566

i just wanted to see if i could get some feedback here on the ammo page.

thanks

[Kishfisser]

I personally have had zero problems with miwall ammunition, through thousands of loads in multiple calibers, however I have heard the occasional complaint through this board, and elsewhere, anywhere from under powered loads to a batch with multiple problems with primers.

Question, are all the problems with the same batch? Also, have you tried other ammunition i.e. factory new or other reloads to see if the problem is there as well? Maybe run some other ammunition to see if the problem persists. This may be the cheapest and easiest check before looking in to problems with the magazine or the firearm itself.

Hope this helps.

[westcoastr]

they are hit or miss. their 40s&w was weak and dirty, although slightly more accurate in my xd40 than WWB. their 308 was actually very good. loaded very hot and my FAL loved it. never had primer/case/FTF/FTE..etc problem.

[bcrich]

I had a few blown primers from 30'06 reloads and noticed the primer pockets were loose when I reloaded them but it was maybe 3 rounds out of 100 so I guess its not too bad! Havent tried the 223 rounds!

[Ballistic043]

ive had light loads from miwall too but it was not the whole box. just a few

[chickenfried]

No problems with their .38, .357, 9mm, or 10mm. But terrible accuracy with their .44 Mag.

[Ballistic043]

lol,

their 44 mag was reliable as HECK through my desert eagle. but very true on the accuracy. i could hardly hold a decent grouping