I just had to do it.

[ARog]

This! Looking at eventually getting a Mark 7 as well...post a vid!

Hi,

it would be great if you could describe set up and operation, and post a video clip of this machine in action.

[Maltese Falcon]

DeLeon / Newslime are going to be pissed...

Congrats.

.

[BajaJames83]

So what I do is pretty simple the setup was really simple.
Im not much of a video guy but ill see what i can do.
I stand there and monitor the process fastest ive ran it so far is 1500rph. still have to watch each powder and bullet drop. but once this system is setup it just needs to be tweaked

[BajaJames83]

already loaded:
5k 9mm
4k .40
4.k .45

I have to say this thing is awesome. In the past i was having issues with the swaging and this would sometimes cause primers to not seat correctly (smear, sideways etc) When I ordered this machine I went ahead and got a large and small one of these http://fastandfriendlybrass.com/shop...swage-rods/18/
since then I can say I have not had a single primer issue. not 1

I was actually going to start a 1050 thread just for those swage rods and help inform you guys of whats out there, because IMHO these rods sloved the problems with the priming system.

[BajaJames83]

well lately I seem to have more friends than usual.

[BigBronco]

well lately I seem to have more friends than usual.

I would think so.

[BajaJames83]

already made 17,000 rounds I think I'm stocked up for the foreseeable future.

5k 9mm
4k .40
4k .45 200gr
4k .45 230gr

setting up to run some more 9mm then to .223

[uzigalil]

How hard with the mark7 and Dillon 1050 is it to switch calibers

[BajaJames83]

its the same as before. the bullet feeder actually takes the most time as you need to make sure the bullets feed properly.

I'd say full about 2 hrs.
thats a full cleaning, lube and teardown and change. Add an extra 15 mins if going from large to small primers.