Tweet
Looking for some opinions.
I'm looking to try out a BPI steel load using 30 grains of Longshot. I use a Mec 600 Jr to load shot shells but am debating if I should just get a powder bushing or a bench mounted powder measure. The Mec is currently set up for my target loads for Winchester AA hulls but the BPI load I chose is Fiochhi based. I'm planning on having to charge and load the shot by hand so what's a good powder measure to use in this case? Or should I just get the corresponding Mec bushing?
My issue with bushings is the consistency of the charges.
I'm looking to try out a BPI steel load using 30 grains of Longshot. I use a Mec 600 Jr to load shot shells but am debating if I should just get a powder bushing or a bench mounted powder measure. The Mec is currently set up for my target loads for Winchester AA hulls but the BPI load I chose is Fiochhi based. I'm planning on having to charge and load the shot by hand so what's a good powder measure to use in this case? Or should I just get the corresponding Mec bushing?
My issue with bushings is the consistency of the charges.
