1X FIRED PMC BRASS

[copterdoc]

What do you guys think of PMC brass 1X fired crimped and non crimped as far as leaking primer pockets and general quality?

[McGuiver]

What caliber?


Sent from my iPad using Tapatalk

[Divernhunter]

I have used it in 223 and 308 without troubles

[Kmai24]

I've loaded pmc in 9mm, 45acp, 223 with no problems..knock on wood

[copterdoc]

.223/5.56

[McGuiver]

1X FIRED PMC BRASS

Are you going to swage them , the crimped primer or chamfer the crimp away?

If you end up with loose primes consistently you need to look at your load data. You are stretching the crap out of your brass.




I have swaged 9mm and 45acp with no problem. About 8 to 10 times reloaded on the same brass cases. No problem with loose primers.

[ar15robert]

I have a large amount of pmc brass from years ago.Been using it without issues,Since it was 1x fired i needed to remove the primer crimp which was no problem with an rcbs reamer tool attached to a drill.

The pockets remained tight even after reloaded 4-5 times.Now federal brass without the primer crimp the pocket is not as tight these are things i notice while using a hand primer tool.

[copterdoc]

Interestingly enough I have had the same experience with fc brass. I have a Dillon Super Swagger 600 but have not used it as of yet. Thank you