Anyone in the SF Bay Area reloading for 50 BMG or 416 Barrett? I'm thinking about getting into 416 and reloading is the only way to male this caliber semi affordable.
Unconfigured Ad Widget
Collapse
|
|
|
|
|
|
|
|
Reloading 416 Barrett
Collapse
X
-
Not quite in the bay area but near Modesto. I load 50bmg. PM me if you want help and I will give you my phone # and addressA 30cal will reach out and touch them. A 50cal will kick their butt.
NRA Life Member, NRA certified RSO & Basic Pistol Instructor, Hunter, shooter, reloader
SCI, Manteca Sportsmen Club, Coalinga Rifle Club, Escalon Sportsmans Club, Waterford Sportsman Club & NAHA Member, Madison Society member -
I am in the Northbay area and load 50BMG and CheyTac so post or pm any questions.Lynn Dragoman, Jr.
Southwest Regional Director
Unlimited Range Shooters Association (URSA)
www.unlimitedrange.org
Not a commercial business.
URSA - Competition starts at 2000 yards!Comment
-
The cost depends on the type of ammo.
For plinker ammo figure 32 rounds per pound of powder and 28 cents for a primer. Brass can be had for $1 a case and bullets run 75 cents each.
For match ammo brass is $5 a case primers are 45 cents and you get about 28 rounds to a pound of VV20N29.
Bullets start at $2 each and go up from there.
I don't shoot factory ammo so can't answer that part.Lynn Dragoman, Jr.
Southwest Regional Director
Unlimited Range Shooters Association (URSA)
www.unlimitedrange.org
Not a commercial business.
URSA - Competition starts at 2000 yards!Comment
-
New commercial .416 is between $6-$7+/round depending on where you purchase and in what quantity (and that's not including shipping charges).
Based on my calculations, my first reloads, if I have to purchase new brass, will run about $4/round. If I just buy some commercial .416 and then reuse that brass, my reloads come in at around $2/round, a significant savings over commercial.
Those numbers are after break even on the reloading gear investment, which I'm targeting at around $500. So after about 100 rounds of reloads, I'm in the $2/round camp or so.Comment
-
My info was for the 50 BMG. JMP loads for the 416 and hopefully he will chime in.Lynn Dragoman, Jr.
Southwest Regional Director
Unlimited Range Shooters Association (URSA)
www.unlimitedrange.org
Not a commercial business.
URSA - Competition starts at 2000 yards!Comment
-
There isn't much money savings in reloading the 416 Barrett. It's costly no matter how you look at it. There are not many bullets to choose from in this caliber, but most cost a bit over $2. Then, it needs a 50 BMG primer and a lot of powder (180-190gr). The problem with the factory ammo is that the bullets are less effective for long range shooting. Then, there is little to no data for different projectiles. On top of that, it's going to be an expensive barrel with a short life.
The cartridge has a lot of potential, but if cost is of large issue, I'd look at the Lapua Mag cartridges. Those are pretty big, and you can run them much cheaper and easily.
I suppose it depends on what your objectives are. If you do decide to reload for 416 Barrett, I'd suggest RL-50 and a ~450gr projectile.Comment
-
Lynn Dragoman, Jr.
Southwest Regional Director
Unlimited Range Shooters Association (URSA)
www.unlimitedrange.org
Not a commercial business.
URSA - Competition starts at 2000 yards!Comment
-
Calguns.net Statistics
Collapse
Topics: 1,870,835
Posts: 25,176,407
Members: 358,862
Active Members: 5,396
Welcome to our newest member, 1776 Arms.
What's Going On
Collapse
There are currently 24081 users online. 162 members and 23919 guests.
Most users ever online was 239,041 at 11:39 PM on 02-14-2026.

Comment