De priming for a Dillon 650

[duckman1]

What are using to de-prime the brass for your long guns?

I am getting set up with a new Dillon Press and need to pick up something to de-prime the brass for .233, .270 and .300WSM what are you using and would you buy it again?

Anything else I need to consider?

Thank you!

[pisarski]

lee de-capping die and yes I would buy again

[Bigedski]

I have my RCBS resizing-depriming die in the #1 toolhead spot and the Dillon trimmer set up in the #4 spot, this way I do my resizing de-priming and over all length trimming. After resizing I clean off the lube.
And my loading setup in another tool head.

[AandO]

I have my RCBS resizing-depriming die in the #1 toolhead spot and the Dillon trimmer set up in the #4 spot, this way I do my resizing de-priming and over all length trimming. After resizing I clean off the lube.
And my loading setup in another tool head.

Same set up as Ed excepting for the decapping part. I use a Dillon Sizing Die with the Decapping pin extended out and the die raised up. The Dillon Decapping pin is Very Heavy duty and lasts me for about 50 to 60,000 decaps per pin.

[MrElectric03]

I run the lee universal deprime die in station 1, dillon rt1200 on station 3, and a sizing die in station 5 set high mainly just to get rid of any small burrs left on the case. It's a great setup, gets expensive pretty quick for multiple calibers but sure is fast.