I got a ghost 3.3 connector for my glock 34 in my attempt to chase the lightest trigger pull possible. During the original fitting process I thought I put in too much over travel so I sent it back in and repeated the lengthy filing process. In the end I got it down to the low three pound range, between 3 pounds 3 ounces and 3 pounds 1 ounce. Though something wasn't right about it. The reset was short, over travel was light but it was like pressing on a wet sponge. I thought about my cz which has what I feel is a perfect trigger. No slop, no pre travel, minimal over travel 1.5lb pull, but the main thing is when it breaks it's like a glass rod. The break is nice and clean.
Weight is only part of the equation and once it's just a few pounds what matters more is a crisp break. I put mu stock block connector back in and left the light striker spring to get a 3.5 pound pull. It has the expected pre travel of a striker fired pistol, it is fairly light, but most importantly it breaks cleanly. I'll figure out how to deal with the over travel which also adds to the reset, but it is much better than a wet sponge.
Weight is only part of the equation and once it's just a few pounds what matters more is a crisp break. I put mu stock block connector back in and left the light striker spring to get a 3.5 pound pull. It has the expected pre travel of a striker fired pistol, it is fairly light, but most importantly it breaks cleanly. I'll figure out how to deal with the over travel which also adds to the reset, but it is much better than a wet sponge.

Comment