Guidance with base and rings

[Trriemferent]

I have a Bushnill scope that I want to put on a Savage 10FCPK with a Seekins base and ring. But Im having a hard time figuring out the ring height. Ive emailed Seekins Precision but I havent received a reply yet. I want to order them this weekend to use next weekend (hopefully) so Im turning to you guys.

Rifle: Savage 10 FCP-K in 308

Scope (in the mail) : Bushnill Elite 6500 4.5-30x50

http://www.bushnell.com/hunting/rifle-scopes/elite-6500/elite-6500-4-5-30-x-50mm,-mil-dot#

Base: https://www.primaryarms.com/Seekins-...0010720001.htm

Ring: ?????

http://www.seekinsprecision.com/parts-and-accessories/scope-rings/scope-rings-30mm-tube.html

which height ring should I be looking at. Any info is appreciated.

[six seven tango]

You'll probably get a lot more responses in the optics sub-forum.

http://www.calguns.net/calgunforum/forumdisplay.php?f=90

[AreWeFree]

If you receive your scope and base you can easily measure for ring height.

[Trriemferent]

Thanks guys. After a little searching I found a few sites that were pretty useful.

http://www.mil-rad.com/scope_ring_calculator

http://www.mil-rad.com/scope_cant_calculator

http://www.mil-rad.com/scopes

http://www.mil-rad.com/rings

[postal]

Usually Low rings will work with a 50mm tube. Some manufacturers do have different heights for low/med/high.... but are usually similar....

I have a bush 3.5-21 x50 DMR with low rings no problem. On savage 10fpLE (older-original accutrigger model)

However I did go cheaper than you with TPS rings and base.

Also check out Vortex rings. They are rebranded Glen Seekins for usually a little less money than the Seekins branded ones.