AR 308 Lower Problem

[Wanghunglo]

So I have this friend that milled out an 80% 308 lower and theres a problem with functionality. All the parts went into the lower fine, but the safety selector is hitting the back of the trigger. The hammer is cocked and it still wont rotate to safe. Im guessing the holes might have been drilled a little off? If so, is it ok to shave a little off the top of the rear of the trigger or the corner of the safety flat? Any thoughts or ideas would be appreciated. Thanks

[tal3nt]

Had the same prob with my ar15. Mil spec would work but an rra 2 stage would get the safety stuck. I think the trigger pin was drilled a little high

[Wanghunglo]

Were u able to do anything to fix the problem?

[Jeymz]

I would take material off the safety instead of the trigger.

[killmime1234]

I would take material off the safety instead of the trigger.

I would take material off the trigger instead of the safety. If you ever use your AR in a defensive situation, you will likely find yourself in court. How will it look when they say you "modified the safety"? A lot of people, on the other hand, modify their triggers.

[Wanghunglo]

Thanks for the input guys.

[tal3nt]

Were u able to do anything to fix the problem?

Kept the milspec trigger in that lower, and made another one for the RRA trigger