Stripper clip question

[GW]

Is there any device that makes loading up stripper clips less of a pain in the ***? This manual labor stuff sucks.

[OldShooter32]

For which firearm?

[GW]

.223 stripper clips

eta or. .308 or 7.62x39
NOT Garand clips

[BumBum]

Stripper clips are devices that make loading the gun easier. Now you want a device to make the device easier?

[BKinzey]

Get somebody else to do it.

Since you can buy ammo on stripper clips I'm sure there is an expensive machine that does it. I don't know of any "consumer" options.

[GW]

Get somebody else to do it.

Its always the simplest solutions that are the best.
After all, isn't that what nephews are for?

[Librarian]

Or, could skip the stripper clips and just load mags -- Caldwell AR-15 Mag Charger Apparently about $100.

[kermit315]

children.

[WARTFROG]

[pterrell]

You mean one of these that comes in every bandolier of LC ammo?



Although I suppose if you want high speed low drag, you could buy this

http://www.amazon.com/Butler-Creek-AR-15-Strip-Loader/dp/B001HBHNGU/ref=pd_sbs_sg_2

[krzgoat]

Haven't seen a device that allows for loading of stripper clips any easier. Strip Lula device is pretty handy compared to the old spoon.

You can use it to load without stripper clips from just loose ammo.

[pterrell]

I always just pressed the floorplate of the mag against my chest and then rested the stripper clip against the back cutout for the BCG hold open and pushed them all down. Rarely had a problem.

[JDay]

He's asking for something to load the stripper clips with, not to load them into a magazine with.

Sent from my SGH-T999 using Tapatalk

[bohoki]

how do you keep that little brass tab from not breaking off after loading them twice

[hollowpoint67]

Just do it when you have relatives over to help pass the time, I started doing it and my Aunts were curious and wanted to help out, they regretted that decision.

Helped get ~1k of .308 on 5 round strippers though