Tweet
So I wanted to get my shooting iron back before i told my.story .
I was out in the desert doing my thing with.my p2000 40sw . No.mag dumps , no speed reloads just casual shooting. When it felt like a fire cracker went off in my hand . The noise/feel was ...larger than normal so immediately set down the pistol and did a hand /finger check and everything checked out . I then looked on the table and did a double take at what was once a complete firearm.
Explosion blew the slide from the from the lower I shoot beside my truck with the tailgate down so the brass goes in the back of the truck bending over to pick that crap up gets old so the extractor shut off the side what I think was the extractor went through the back window of my truck I still haven't found it the lower back strap above the back strap shattered and all the parts with the hammer and we're all bent and some were missing I'm going to try to post pictures so I called HK see if what was up with the warranty they said that I had to send it in so they can look at it . The representative at hk said in the meantime contact the Ammunition Company which was Federal and let them.know so I did. They said they needed a lot number on the box and I had only had a few of those rounds left so I had condensed them in another box so I didn't have the lot number and they said well when I get the report from HK send it to them and they will evaluate situation all said and done they check it out and apparently the failure was with the aluminum case 250 bucks to get it repaired had to get a new lower new extractor in a couple of the parts new serial number Federal said they pay for half so I got it replaced for 125 bucks and all of you and the new d r o s I'm going to try to post pictures so if this post doesn't have pictures attached to it I'll post them right after
I was out in the desert doing my thing with.my p2000 40sw . No.mag dumps , no speed reloads just casual shooting. When it felt like a fire cracker went off in my hand . The noise/feel was ...larger than normal so immediately set down the pistol and did a hand /finger check and everything checked out . I then looked on the table and did a double take at what was once a complete firearm.
Explosion blew the slide from the from the lower I shoot beside my truck with the tailgate down so the brass goes in the back of the truck bending over to pick that crap up gets old so the extractor shut off the side what I think was the extractor went through the back window of my truck I still haven't found it the lower back strap above the back strap shattered and all the parts with the hammer and we're all bent and some were missing I'm going to try to post pictures so I called HK see if what was up with the warranty they said that I had to send it in so they can look at it . The representative at hk said in the meantime contact the Ammunition Company which was Federal and let them.know so I did. They said they needed a lot number on the box and I had only had a few of those rounds left so I had condensed them in another box so I didn't have the lot number and they said well when I get the report from HK send it to them and they will evaluate situation all said and done they check it out and apparently the failure was with the aluminum case 250 bucks to get it repaired had to get a new lower new extractor in a couple of the parts new serial number Federal said they pay for half so I got it replaced for 125 bucks and all of you and the new d r o s I'm going to try to post pictures so if this post doesn't have pictures attached to it I'll post them right after
Comment