How to install MMG on AK w/ AR adapter

[Jimmy Deuce]

Just as it says got mine in today but I am unsure if I need to trim the actual grip of just the adaptor. Any help would be great.

[tenpercentfirearms]

You will most likely need to trim the MMG. The adapter should be fine as it is. Be sure to go a little at a time. The one I did I made the mistake of following the line exact and it was too far. I just used my bench grinder wheel to trim it down a bit at a time.

[bigthaiboy]

I dremelled, trimmed, sanded and painted the base of the adaptor (which when fitted is in direct contact with the receiver) using the original AK pistol grip base as a template to get the correct size. This way it fits as the original pistol would do, and the "hump" on the MMG clears the adaptor.

The top of the MMG has to be trimmed and sanded very gently to remove just enough to get a nice fit onto the fixed stock.

MMG.JPG

[M. Sage]

I trimmed both. If you're cheap and don't mind working, a rasp takes material off pretty fast.

Remember: measure twice, cut once. Trim a little, then test fit and see what needs trimming next. Rinse, repeat.

[SunriseF150]

I did some modifying to both. But then again, I Duramix'd them together and got rid of that finger hump towards the top of the MMG. A little more work on it and it should look like it was made for the AK. I'll have to snap a pic of what I got done so far. It feels way more comfortable than before as 2 seperate pieces.

[Jimmy Deuce]

Well any advice would help I grinded and sanded the grip part only and the fit is not quite right. Still needs woork and does not look that great.

[Shane916]

I just dremeled down the grip a little and it fit fine.

Where are the problems arising for you?