Tweet
AR spring to follower assembley
Decided to clean my C mags today after disassembly i noticed that one mag had the spring seated opposite under the follower to the 2nd mag so now im at odds which is the correct position.
The spring ends in a right angle seated under the follower it will go in the mag either way but i cannot tell if that right angle at the end of the spring sits towards the back of the mag/ follower primer side or the other way round towards the bullet end.
I decided to assemble them with the right angle end of the spring towards the primer end they load fine just not sure if this is correct.
The spring ends in a right angle seated under the follower it will go in the mag either way but i cannot tell if that right angle at the end of the spring sits towards the back of the mag/ follower primer side or the other way round towards the bullet end.
I decided to assemble them with the right angle end of the spring towards the primer end they load fine just not sure if this is correct.
Comment