NEED HELP!! Bullet Button Issues.

[mwt1980]

OKay i am going to the range tomorrow morning first thing and i was getting my rifle set. I tightened my BB to much and now its not working.

How the heck do i loosen it? can't figure it out.

HELP!!!!!!!!!! hahahaha

[Guns R Tools]

Which version of BB did you buy?

[mwt1980]

unsure....bought the lower complete

[TheRossRocket]

I tightened my BB to much and now its not working.

How the heck do i loosen it? can't figure it out.

Can you elaborate a little bit? what do you mean by not working?
Can you push the button and drop the mag or is it not dropping the mag with the use of a tool?

If you tightened it, you should be able to loosen it.... just do the opposite you did to tighten it...
To loosen, stick a tool inside the button as far as you can and if you look on the opposite side of the lower receiver the catch should pop out some, spin that catch one whole turn counter-clockwise, then remove the tool, then test again. (just be careful not to damage your finish if you loose your grip on the button)

As for which bullet button you have, if you look inside the hole, is there just a round piece? or is their a round piece with a line through like two halves of a circle coming together?

Full circle= bullet button
Two halves coming together= raddlock

[mwt1980]

Its a bullet button.... It was loose and sometimes it would push the other side out to far and get stuck.. so i tightened it. now it does the opposite. I push it down and it doesn't depress enough to release the mag. i am trying to back it off a bit, but can't seem to do it.

Was wondering if there was a trick i was missing. Or my BB might be busted. If i depress the BB and wiggle the mag it pops off...just not working smooth like it did an hour ago hahaha...cuzz i f@@ked it up aparently.

[mwt1980]

yes of course

[mwt1980]

the problem is...its to tight. So when i push the middle button it doesn't release the mag.... Im sure its a simple fix i just don't know how to do it.

[CHS]

Slow down and breath.....

Now, buy this:

http://riflegear.com/p-498-vamfire-freelock-tool.aspx

Problem solved.

[evidens83]

If you can tighten it you can loosen it. Or pick up a BB wrench like said above and be done with it. Keep it inside your PG so you dont lose it.