G19 Gen3 Boresight Check

[tcd511]

So was going through all my 9mm's with a Sightmark laser boresight just checking the sights to see how on they actually were. Everything from S&W's, Springfields and H&K all came in good. The G19 though showed the laser high to the left. Did a Google search and found a thread on another page where someone ran into this as well and talked to Sightmark and was told that on Glocks that is what will happen unless you remove the extractor. Anyone else ever heard of this?

[9Cal_OC]

I usually have that issue with .40 S&W laser bore sight and the extractors slightly cocking the laser off center

[Vinnie Boombatz]

Never had that issue with the two Gen3 G17's I own. Installed aftermarket sights on both myself, verified install with the laser borsesight before going to the range. Both firearms are dead on.

[DDM4556]

Have you put any rounds through the gun? A lot of us have a percentage of their collection that’s unfired and tucked away in the safe somewhere. But the only real way to tell if you have a problem is by shooting it.

I have never had an issue with any of my gen3 Glock’s. But I also still have a couple new in the box, so I suppose it’s possible.