1911 - 10rd Magazine Rebuild/Refresh

[vinny_land]

Hello everyone,
Figure I would try in General Section since no hits on the Handgun Section...

Has anyone replaced the spring and follower on the 10-rd CMC Power Mags with the Wilson Combat spring and follower set listed below:

https://shopwilsoncombat.com/Spring_Follower-Kit-Wilson-10-rd-45-ACP-Full-Size-Mag/productinfo/47SFK-10/

I've done similar conversion to other 8-rd magazines (MecGar, ACT, Colt, CMC) and have reduced the capacity from 8 to 7 after changing spring and follower. Wanted to know if I would be able to maintain the same round count at 10 or would be going back down to 9 due to the different size follower in the CMC Power Mag body.

Thank you in advance!!!
Vinny

[FeuerFrei]

Called them yet?

https://www.wilsoncombat.com/contact/

[vinny_land]

^Figure I would ask the community before going that route.

[Garbcollector]

Seem like a good deal if the work

[vinny_land]

Response from WC staff...

The polymer follower is concave, so it should work keep the mag capacity the same. Hope this helps.
Respectfully,

Kent Villines
Firearms Service Manager
2452 CR. 719
Berryville, AR. 72616
Phone 800-955-4856 ext 299