Parkerize

[rspar]

I have a Walther PP 32 that has had some significant rust on the slide and the finish is gone, I'm thinking of buying a diy parkerizing kit. Any thoughts? Or should I send it out since it's just the slide? You dip the whole thing so will that throw off the clearances? I see many people have done it so I'm guessing no.

[Zamble]

[-hanko]

ABS pipe works just find for parking and rinse tanks. Still, mucho work to set up a good park line. I'd send it out.

[ARDude]

I have a Walther PP 32 that has had some significant rust on the slide and the finish is gone, I'm thinking of buying a diy parkerizing kit. Any thoughts? Or should I send it out since it's just the slide? You dip the whole thing so will that through off the clearances? I see many people have done it so I'm guessing no.

PM Randall @ ar15barrels on this forum. I'm sure he can do it. He is in the L.A. area.

[rspar]

Thx I'll check with Randall I have a cz25 I picked up from a relative a few decades ago that needs a new finish as well but I'm not sure I'm going to spend much money on it.

[MosinVirus]

Yup, Randall will do an awesome job!!!

[ar15barrels]

[ColdDeadHands1]

Randall, will you park my recently built M1919? I thoroughly degreased it and bead blasted it prior to riveting it up.

[ar15barrels]

Randall, will you park my recently built M1919? I thoroughly degreased it and bead blasted it prior to riveting it up.

I don't know if a 1919 would fit in my tanks.
What is the maximum width and height of the riveted receiver with everything stripped off of it that is hand tool removable?