Bcg problem

[Syke001]

[ErikC12]

Sounds like the lips are sticking up too far. Is this with all mags, or just certain ones?

[SkyHawk]

Something is out of spec. What kind of lower is it?

[Over It]

If you load 9 or 8 rounds in the mag, does it exhibit the same characteristics?

[kcheung2]

Do we even know what kind of gun this is? Or what brand parts?

[Syke001]

Only tryed hex mag so far. And it’s a polymer80 lower

[kcheung2]

Only tryed hex mag so far. And it’s a polymer80 lower

So you have a 9mm pistol right? Or a .40? Or a .308? Because Polymer 80 makes stuff for all those cartridges.

Maybe you should learn about how to ask for help on the internet. It usually involves giving specific details.

Or even something as basic as are the Hexmags the 1st gen or 2nd gen?

[ar15barrels]

I know what the problem is.

[MrBlazito]

What the problem be? ^

[ErikC12]

Polymer 80 lower? Probably milled out of spec.

[Mandingo27]

My lwrc pistol lower doesnt like magpul mags. I have the 33.3 tactical calcatch fixed mag device with the modified bolt catch which closes after the last round is fired and the bcg always gets hung up on the mag follower when I'm using magpul mags but when I run a lancer or an ets mag it doesnt happen

[Triple765]

If you load 9 or 8 rounds in the mag, does it exhibit the same characteristics?

Freedom week has been over for a while now. I'm still not used to low capacity talk

[Aeneas]

Freedom week has been over for a while now. I'm still not used to low capacity talk

Haha yes. Keep in mind though, magazines should be considered consumables, as they do wear out with enough use. I'm hoping that we get a proper court ruling before that becomes an issue for most folks.

[AlHO1966]

I’m still not sure how any of you could understand what the OP was trying to ask?

[SkyHawk]

It was very clear to me. BCG sort of gives it away.