Impossible Roll Pin on MP5 Front Sight

[mcb8]

[67Cuda]

Bigger hammer and make sure it's held SECURELY.

[Leel]

liquid wrench

[SkyHawk]

Bigger hammer and make sure it's held SECURELY.

This, bigger hammer. And a proper roll pin punch. And a very solid background, like an anvil. Jig it and secure it properly before pounding.

[russ69]

This, bigger hammer. And a proper roll pin punch. And a very solid background, like an anvil. Jig it and secure it properly before pounding.

Put it on a solid bench, you'll be surprised how much easier it is.

[45guru6918]

Throw it in the freezer for a bit or get some of that freeze off spray for skin tags. Its what i do for pressing out hard to remove bearings works everytime

[TRAP55]

Like Skyhawk said, "a proper roll pin punch". Use anything else and it won't be a roll pin anymore, it'll be a cold forged rivet.

[Leel]

was having a biich of a time with my taper pins once, moved to concrete floor came out instantly

[readysetgo]

Crisco!

Crisco and JB weld.

[P5Ret]

It's 1/8 for an MP5, but a clone it could be with parts from anywhere, and they are not all interchangeable, even if built under license. I'd check it if it is a 1/8 roll pin try heating it up a bit with a solder gun first. I've seen some put in with locktite.

[Simi762]

Try it after a few mag dumps