Screw build loctite?

[B.D.Dubloon]

I just got an AK kit and it came tapped for a crew build with the screws included. I figure I will try it as a screw build and then if it doesn't work out I'll rivet it. Is blue loctite tough enough for the job? I don't want to use red because I will most likely want to take it apart and rivet it sometime in the future. Any advice would be appreciated, especially from people who have done screw builds before.

Also, a bullet button doesn't count towards compliance does it?

Thanks,
BDD

[Beelzy]

Use the Red. It will take the heat from the gun better. It is not that big a
pain removing the screws after using it. Just make sure the gun is "warmed"
up before any dis-assembly.