perfecta ammo

[tonyt22]

Just picked up 100 rounds of223 and 100 rounds of 40 for 49 bucks so just about .25 a round pretty good had to gfs discount card

[Red-Osier]

Good plinking ammo, Location?

[OutlawStar]

Its inexpensive ammo, good for plinking. I had a bit of hiccup with my M&P40c with regards to feeding; it wasn't going fully into battery. The next magazine with copper jacketed bullets fed just fine. Next magazine with perfecta had the same feeding issues. I assume its because they're brass jacketed and there was just too much friction, or the bullet was slightly out of spec. Who knows.

Won't stop me from buying it in the future. FYI for those that care, the ammo is made in Italy, non corrosive boxer primer, brass cases, brass jackets.

[superhondaz50]

I had the same issue with my 40 shield, the pefecta has a smaller extractor groove than other 40 brass, the extractor was hanging up on it since it didn't fit the brass groove right. so I rounded and polished the extractor and it runs perfect now with all ammo. The perfecta works flawlessly in my Steyr M though, and it's reloadable brass.

[superhondaz50]

Perfecta is $12.99 at my Walmart btw

[Red-Osier]

Its inexpensive ammo, good for plinking. I had a bit of hiccup with my M&P40c with regards to feeding; it wasn't going fully into battery. The next magazine with copper jacketed bullets fed just fine. Next magazine with perfecta had the same feeding issues. I assume its because they're brass jacketed and there was just too much friction, or the bullet was slightly out of spec. Who knows.

Won't stop me from buying it in the future. FYI for those that care, the ammo is made in Italy, non corrosive boxer primer, brass cases, brass jackets.

Made by Fiocchi in Italy, Distributed by Tulammo.

[OutlawStar]

I had the same issue with my 40 shield, the pefecta has a smaller extractor groove than other 40 brass, the extractor was hanging up on it since it didn't fit the brass groove right. so I rounded and polished the extractor and it runs perfect now with all ammo. The perfecta works flawlessly in my Steyr M though, and it's reloadable brass.

Thats what it was, it wasn't sliding under the extractor like every other ammo. I just tried chambering a round and the exact fail to feed happened. I'll have to remember to strip the extractor out and polish it, I've only done the bolt face.

[tonyt22]

I've shot it out of my xd40 no problems haven't tried it out of my AR but I'll see this weekend till amazed .25 a round for brass is pretty damn good

[Red-Osier]

I've shot countless rounds of .40 Perfecta and never had a problem.

[Par5In2]

I got to B class uspsa using perfecta 115 grain. I only stopped cause reloading was waaaaaaaay cheaper, lol.

9.98/50 115 9mm at my local walmart.

[Hhsohn]

Not sure if it matters but fed about 100 rounds of .45 acp Perfecta through a S&W 745 with out any issues.

[jstert]

at nearby walmart i got the last two boxes of perfecta 380acp to try in my new to me baikal ij 380acp. only $13 each, couldnt pass it up. next week i will try it and report.


Sent from my iPad using Tapatalk