Benelli M4 Replacement Parts

[JDPhx501]

Going to order some parts from Brownells now they've updated my account with my CR license.

What small, replacement parts for my Benelli M4 should I stock up on? I was thinking so far:

-Firing Pin
-Firing Pin Spring
-Firing pin retaining pin
-bolt carrier CAM pin

any other parts I should get now while available?

What's the round count in general for replacement parts on this platform?

[Caligvla]

I have easily shot over 8000 rounds through my Benelli M4, I have never had to replace anything except for the magazine tube spring.

[JDPhx501]

Thanks for the input!

I've got about 600 rds thru it. Mostly game loads and a few buck.

Already have the FFT full mag tube and replacement spring and follower so that part is gtg.

I'll probably just get a replacement firing pin for now

[Caligvla]

I am pretty confident the firing pin will outlast your great grandchildren...

[Case]

Go here for better info on the m4: http://www.benelliusa.com/forum/foru...php/17-Benelli

I don't think any of the parts you listed will wear out at your current shooting rate. Buy the o-rings that go on the gas tubes. They wear slowly but if you nick one during takedown or cleaning you will need a new one immediately.

[JDPhx501]

Good suggestion.

A lot cheaper than the pin too haha

[JDPhx501]

take what you read in the Benelli forum with a grain of salt.

poorly moderated and misinformation or lack there of flows freely.

download this and prepare your weapon for the duty you anticipate.
TM10698A-10/1 for the M1014

A lot of fan boys too. Thanks for the link. More helpful than the instruction book

I love my Benelli and its my only gun that I will absolutely never give up but a fanboy never am I