Tweet
I have a old 20 gauge 870 with a non vent rib 29" barrel. I would like to cut the barrel down to 24" or 25" My question is, there a possibility I can get a gunsmith to bore and thread the barrel for a choke?
-
Some say that he once mooned two prostitutes just for a round of drinks, but wasn't surprised by the reply......They call him, the Hutch
Some say that he rode a dirtbike 7k miles across the country and that he once applied Bengay to his own testicles for a mere $50............They call him, the Hutch -Top Gear
http://media.liveauctiongroup.net/i/...CCAB7CE8D70F60 -
Yes.
But don't have your barrel cut until measurements are made. Many of the older barrels have OD's not concentric with the ID. -
With enough money anything can be done or made
Are the new 20ga 870's that you can pick up for $280 plus tax threaded?
Would one of those meet your needs?"Americans have the right and advantage of being armed - unlike the citizens of other countries whose governments are afraid to trust the people with arms." James Madison
Comment
-
Some say that he once mooned two prostitutes just for a round of drinks, but wasn't surprised by the reply......They call him, the Hutch
Some say that he rode a dirtbike 7k miles across the country and that he once applied Bengay to his own testicles for a mere $50............They call him, the Hutch -Top Gear
http://media.liveauctiongroup.net/i/...CCAB7CE8D70F60Comment
-
The barrel can be thick, but sometimes the bore is not in the middle of the barrel. One wall may be thicker than the other.Comment
-
Now I understand. So with that said I should send it to a gunsmith.
Any recommendations???Some say that he once mooned two prostitutes just for a round of drinks, but wasn't surprised by the reply......They call him, the Hutch
Some say that he rode a dirtbike 7k miles across the country and that he once applied Bengay to his own testicles for a mere $50............They call him, the Hutch -Top Gear
http://media.liveauctiongroup.net/i/...CCAB7CE8D70F60Comment
-
www.roseactionsports.com He goes by guncat on the blogs and the guy is good at this. I use him for any barrel workJD McGuire, Owner
AI&P Tactical
Remington Law Enforcement Armorer
Mossberg LE Armorer
www.aiptactical.com
www.tacticalgunslings.com
If you're going to a gun fight, take a shotgun. If you can't take a shotgun, don't go.Comment
-
Got my Barrel back from Steve at Rose Action sports $135 bucks is all it cost to thread and shorten the barrel plus it came with 3 chokes and a choke wrench.Some say that he once mooned two prostitutes just for a round of drinks, but wasn't surprised by the reply......They call him, the Hutch
Some say that he rode a dirtbike 7k miles across the country and that he once applied Bengay to his own testicles for a mere $50............They call him, the Hutch -Top Gear
http://media.liveauctiongroup.net/i/...CCAB7CE8D70F60Comment
There are currently 13660 users online. 89 members and 13571 guests.
Most users ever online was 239,041 at 10:39 PM on 02-14-2026.
Comment