Bullet button for saiga-12 v30 magwell

[torsf]

This is squarely in the need column:

http://www.reddragunweapons.com/saiga-12.html

Now the big question is - how to deal with the magwell & CA compliance. I doubt that the regular s12 bullet button would work.

Option 1 - middleman transfer that either welds/screws/etc a mag in place, and then figure something out once the weapon is in state. I'd probably send it to PRK arms to figure something out if I went this route.

Option 2 - middleman transfer that fabs up a bullet button

Any ideas? Anybody else planning on getting one of these?

[Mercenetti]

I am planning on getting one for my Saiga 12 and ive ran into the same problem RandR makes one that is CA compliant tho it is like 175 dollars if your a big spender then go to there site and send them an email saying you want to buy one


.http://randrtargets.com/

[Mercenetti]

just buy it and DIY or get your GS to do it. either way you will have the best magwell on the market and it will be CA complaint

[torsf]

just buy it and DIY or get your GS to do it. either way you will have the best magwell on the market and it will be CA complaint

The magwell on the saiga-12 I linked to above is installed on the shotgun at the factory in Russia, so the RandR magwell has no bearing on this, unless it uses a similar magazine release.