I know the old cutts compensators went out of vogue at the same time fins disappeared from the American automobile, but I like them.
I like them because they work. I picked up a used model 11 (Browning auto-5 clone) w/ a cutts installed, and it worked great (after replacing a cracked spring). made me a big fan of both the model 11 and the cutts.
I have just picked up another model 11, w/ two barrels. One w/ a ploy choke, another with a 30" plain barrel. the Poly barrel is numbers matching, so I'm planning on leaving it as is.
The 30" barrel is going to the WECSOG chop shop at some point. I'd like to put a cutts on this as well, permanently mounted as close to 18" as is possible on the recoil operated model 11. My question is, does anyone know if there is a limit (other than the fore-end, and the ATF mandated 18" minimum) to how far back a cutts can go on the model 11 (auto-5/ savage 720) type action? Will too short a barrel interfere with the recoil operated action?
Thanks
I like them because they work. I picked up a used model 11 (Browning auto-5 clone) w/ a cutts installed, and it worked great (after replacing a cracked spring). made me a big fan of both the model 11 and the cutts.
I have just picked up another model 11, w/ two barrels. One w/ a ploy choke, another with a 30" plain barrel. the Poly barrel is numbers matching, so I'm planning on leaving it as is.
The 30" barrel is going to the WECSOG chop shop at some point. I'd like to put a cutts on this as well, permanently mounted as close to 18" as is possible on the recoil operated model 11. My question is, does anyone know if there is a limit (other than the fore-end, and the ATF mandated 18" minimum) to how far back a cutts can go on the model 11 (auto-5/ savage 720) type action? Will too short a barrel interfere with the recoil operated action?
Thanks

Comment