Unconfigured Ad Widget

Collapse

870 express foregrip installation?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ArcLight
    Banned
    • Jan 2009
    • 284

    870 express foregrip installation?

    I just purchased a shortened foregrip for my 87o express so i can mount my side saddle. However i cannot seem to figure out how to install it. Can anybody point me in the right direction. Any help advice would be great thanks.
  • #2
    savasyn
    Veteran Member
    • Aug 2007
    • 3201

    So you just bought the new forearm grip, not a whole new forearm assembly, I take it?

    Strip the shotgun so that you can remove the forearm assembly, look at the front of the assembly and you'll see a ring with two notches in it, one on each side. This is the nut that holds the grip on. You can use strong needle nose pliers or some other tool to get that nut out of there, but nothing is as easy as using the proper removal tool like one of these: http://www.brownells.com/.aspx/pid=9..._FOREND_WRENCH

    Anyway, once you have it loose, swap the grip and put the nut back on. This is MUCH easier with the real tool, but doable without.

    Comment

    • #3
      aippi
      Senior Member
      • Jun 2009
      • 2302

      There is a forend tube nut wrench built into your weapon. Break the weapon down and remove the the forend tube assemble by following your owners manual. You need to know how to do this anyway to clean the weapon. When you remove the forend tube assembly the bolt and slide with come with it. The slide is what the bolt sits on. Take that slide and you find it fits the forend tube nut, and will fit right in those two slots in the forend tube nut. Use it as a forend wrench just to change your forends out but get a forend wrench to have as if the weapon gets wet, or about once a year you need to pull it and clean the forend tube assemble and put a light coat of oil on it to protect it. the slide works in a pinch when you don't have a wrench.
      JD McGuire, Owner
      AI&P Tactical
      Remington Law Enforcement Armorer
      Mossberg LE Armorer
      www.aiptactical.com
      www.tacticalgunslings.com
      If you're going to a gun fight, take a shotgun. If you can't take a shotgun, don't go.

      Comment

      • #4
        savasyn
        Veteran Member
        • Aug 2007
        • 3201

        Originally posted by aippi
        Take that slide and you find it fits the forend tube nut, and will fit right in those two slots in the forend tube nut. Use it as a forend wrench just to change your forends out but get a forend wrench to have as if the weapon gets wet, or about once a year you need to pull it and clean the forend tube assemble and put a light coat of oil on it to protect it. the slide works in a pinch when you don't have a wrench.
        Good tip! Thanks

        Comment

        • #5
          ArcLight
          Banned
          • Jan 2009
          • 284

          Thanks for the advice I was finally able to get it on.

          Comment

          Working...
          UA-8071174-1