Unconfigured Ad Widget

Collapse

Ponsness Warren 375 reloader

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • bhilliker@comcast.net
    Senior Member
    • Mar 2012
    • 755

    Ponsness Warren 375 reloader

    Looking for someone who is experienced with a PW shot loader. I am a rifel/pistol loader looking to start shot loading and just bought the PW press. Would like to find an SME to walk me through the equipment side of the process. TIA
  • #2
    joego
    Junior Member
    • Jun 2011
    • 2

    There are a few good videos on youtube about the basics and the book is also a good place to look. I find that they are very helpful over the phone and the taper sizing dies are a good investment.

    Comment

    • #3
      shovelon
      Senior Member
      • Mar 2012
      • 1852

      Join ShotgunWorld.com. There is a shotshell reloading forum.

      I have a P/W 900. Got it with only 100 reloads on it. It was a little intimidating at first but got the routine. Yours will be super simple. Yours has fixed sleeves like mine and if you crush a hull you might have to sever the crushed part with a sharp carving knife. The best part is you can cycle the turret without pulling the handle. really good for loading spreader shells.

      Don't know what gauge you are loading but if 12 gauge like mine stick with tapered base hulls like gun club or AAs. I also reload Winchester super target and universals but they can wear out quickly.

      For 20 gauge Federal straight hulls can be reloaded with Gualandi wads from Balliistic Products, as tapered hulled shells are really hard to come by.

      What ever you do stick to the recipe for primers, wads, and powder. Odd pressures can be disastrous.
      Alfred E. Neuman 2024

      "The Hillary Clinton school of failure."

      Comment

      Working...
      UA-8071174-1