DDI-12 or Saiga-12, 10 rd magazine release??

[SkylerD]

Guys,

I bought a DDI-12 which is esentially a Saiga 12 clone. Being in California I got it with a raddlock device which releases the factory 5rd magazines just fine.

It will not release the 10rd Saiga magazines though as they latch a little different. There is just no ability to slide it in there to release it.

I can pull the 10rd back out the way it went it. Takes a bit of force but isn't that bad. Question is will that ultimately swear down the plastic tabs on the mag and or inside the gun. The gun's tab is plastic too.

There has to be a solution for this. I can't be the only person in CA w/ a raddlock device trying to run a 10rd mag.

Thanks

[Mitch]

There has to be a solution for this. I can't be the only person in CA w/ a raddlock device trying to run a 10rd mag.

You might be. I had a 10 round Saiga 12 magazine a few years ago and it seemed to be ridiculously huge. I don't know what happened to it, but I don't have it anymore.

[SkylerD]

Yeah it is big, I would take a 15 if I could get it haha