I recently picked up a very sad, abused Mossberg 835. It sported the worst alleged Cerakote job I've seen lately in a weird off-white, with the stock, forend and magazine cap Duracoated light tan. The stock had been damaged at the tang and the PO used JB Weld to fill the damage. That might have been all right, but the "repair" was done with the trigger housing in place. Thankfully, he didn't glue the trigger housing to the stock, but the stock had to be removed in order to pull out the trigger housing.
The trigger was a little "soft", the seller said. Yup, it was. The adjustment screw had been backed out all the way. That didn't make too much difference though, since the plastic trigger housing was cracked at the cross pin hole.
The Cerakote had been applied so thickly that the barrel would not come out of the receiver by hand and had to be assisted with a soft mallet.
And the final indignity... the plastic safety button had broken. Instead of replacing it, the PO simply filled the rear half of the safety button recess with JB Weld.
I almost passed it up... but like some folks collect abandoned and abused pets, I can't pass up a neglected, abused or forgotten firearm if I think it can be restored to a useful condition. In this case, I think that with the Cerakote redone, the safety and trigger housing replaced, and an 18 1/2" barrel (which is available from Mossberg although it doesn't show in any of their catalogs) installed, it should be a pretty useful defense shotgun capable of firing anything up to 3 1/2" shells.
Now for the "before" pic:
The trigger was a little "soft", the seller said. Yup, it was. The adjustment screw had been backed out all the way. That didn't make too much difference though, since the plastic trigger housing was cracked at the cross pin hole.
The Cerakote had been applied so thickly that the barrel would not come out of the receiver by hand and had to be assisted with a soft mallet.
And the final indignity... the plastic safety button had broken. Instead of replacing it, the PO simply filled the rear half of the safety button recess with JB Weld.
I almost passed it up... but like some folks collect abandoned and abused pets, I can't pass up a neglected, abused or forgotten firearm if I think it can be restored to a useful condition. In this case, I think that with the Cerakote redone, the safety and trigger housing replaced, and an 18 1/2" barrel (which is available from Mossberg although it doesn't show in any of their catalogs) installed, it should be a pretty useful defense shotgun capable of firing anything up to 3 1/2" shells.
Now for the "before" pic:




Comment