Has anyone got a local (Orange County) gunsmith that does or has done bedding? I have a new stock ordered and would like to bed this one.
Unconfigured Ad Widget
Collapse
|
|
|
|
|
|
|
|
Bedding a 10/22
Collapse
X
-
Bedding a 10/22
Tags: None -
Did I post in the wrong area?? So many of you have 10/22's none are bedded?? really??? lol -
Check over at rimfirecentral.
They have a few threads showing you how to do it yourself.
But if your not up for it, thats a good place to ask as wellhttps://www.activejunky.com/invite/132380
Mr.Rebates sign-up referral link: http://www.mrrebates.com?refid=1034188Comment
-
-
A single action screw makes bedding not worth the cost for most 10/22 owners. That and most 10/22 owners wont ever invest enough money into their rifles to get to that level.Comment
-
Mongoosev8 the more I'm looking at this bedding, the more I'm looking at adding a rear tang. as for the level, my new bench rifle is a Falcon, built by Baity's. It's a level beyond my capabilities, but it pushes me to achieve a smaller target. and it's a level way beyond what I can expect from my 10/22, but I find the building as much fun as shooting.Comment
-
I've never seen the need to bed a 10/22, that's just me. Freefloating, now that I like! I know several national shooters that don't bed 22's, I guess some do. As stated, RFC is about the best source IMO. There are several champion shooters that frequent that board, they wont tell you, but everyone else will, lol. Good luck with whatever you do! Have fun!Yes I took the pic, no I didn't go swimming!Comment
-
When you upgrade to a rear tang/screw you will certainly benefit from bedding. And I have owned/shot/seen some mighty accurate 10/22's that would give a high end benchrest rimfire a run for its money. Only catch is they usually cost more than fancy bench guns haha.Comment
-
Side note. If you bed the receiver and first inch or so of the barrel you can minimize the forward to aft rocking problem found in a single action screw design. But to totally lock it down the rear tang with pillars plus bedding is best. Next step would be to thread the barrel to the receiver to eliminate the barrel droop issue.Comment
-
That would leave you with the same problem. The receiver can move in relation to the barrel. If your sighting system is wholly on the barrel it doesnt matter. But if you use a scope or receiver mounted rear sight then it can drive you crazy.Comment
Calguns.net Statistics
Collapse
Topics: 1,870,835
Posts: 25,176,401
Members: 358,862
Active Members: 5,396
Welcome to our newest member, 1776 Arms.
What's Going On
Collapse
There are currently 26557 users online. 138 members and 26419 guests.
Most users ever online was 239,041 at 11:39 PM on 02-14-2026.

Comment