Ruger 10/22 Take-Down Stock Adjustment

[GunDog]

Finally able to pick-up my new Ruger 10/22 Take-Down rifle. The forend seems to be off-set from the rear stock by just a few degrees. I recall a few months ago reading a thread here on the Rimfire board that discussed how to make the stock adjustment to line up the two stock halves. Seemed like the two hex head machine screws in the front of the receiver had to be loosened and something adjusted before re-tightening the screws. I did a search but, was unable to locate the thread. Can someone help, please?

[secret.asian.man]

it's sticky up above.

but here you go. http://www.calguns.net/calgunforum/s...d.php?t=571152

[GunDog]

Sorry 'bout that. I saw the sticky right after I posted this thread. Gomen! Thanks secret.asian.man.